Comparison of the machinability and wear properties of magnesium alloys


AKYÜZ B.

International Journal of Advanced Manufacturing Technology, cilt.75, sa.9-12, ss.1735-1742, 2014 (SCI-Expanded) identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 75 Sayı: 9-12
  • Basım Tarihi: 2014
  • Doi Numarası: 10.1007/s00170-014-6256-y
  • Dergi Adı: International Journal of Advanced Manufacturing Technology
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.1735-1742
  • Anahtar Kelimeler: AS series, AZ series alloys, Cutting force, Machinability, Magnesium
  • Bilecik Şeyh Edebali Üniversitesi Adresli: Evet

Özet

© 2014, Springer-Verlag London.AZ and AS series magnesium alloys were used in this study and had different contents (i.e., 0 to 9 wt.% Al). The effect of zinc (Zn) and silicon (Si) on wear resistance and machinability was analyzed in AZ and AS series magnesium alloys. Zn amount in AZ series (1 %) and Si amount in AS series (1 %) were kept at a fixed rate. The effect of the changes in Al amount on hardness, wear resistance, and machinability in AZ and AS series magnesium alloys was comparatively analyzed. A higher increase was observed in the wear resistance of alloys in AS series magnesium alloys due to the rise in Al amount compared with AZ series. Intermetallic phases found in the microstructure of alloys (β-Mg17Al12 and Mg2Si)were established to have an impact on the wear resistance and machinability of alloys.